Filter
Top Products
PCL Menu
Chapter 3: Using the Control Panel
❖
3-19
Figure 3.8 PCL Menu options showing factory settings
Option
Setting
Description
Copies
1*
- 99 Number of times each page is printed.
Most software applications override this setting. If
your application does not, the printer assumes the
default setting here.
Font Source
Internal*
Upper
†
Lower
†
Soft
†
†
Upper
and
Lower
appear
only when a font card is
installed.
Soft
appears
when there is a
downloaded font.
Location of the default font in PCL.
Internal
refers to the font set residing in the printer’s
permanent memory. These fonts are resident in the
printer and cannot be altered.
Upper
and
Lower
refer to the two font card slots and
appear
only
when a font card is installed in a slot. See
Chapter 1: Introduction
(page 1-3) for location of the
font card slots.
When a font card contains its own default font, the
current
Font Source
setting is overridden. You must
change the
Font Source
setting if you do not want to
use the default font on the font card.
Soft
refers to fonts permanently downloaded to either
printer memory or to a printer hard disk.
Soft
appears
only
if there is a permanently downloaded font.
The
Font Source
setting returns to its
factory setting (“
Internal
”) if
Symbol Set
(page 3-25) is changed.
If the
Font Source
setting specifies a
location other than “
Internal
,”
Font
Number
(page 3-20) reverts to 0
automatically.
Note
WUG-CH03 Page 19 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM