Filter
Top Products
PostScript Menu
Chapter 3: Using the Control Panel
❖
3-33
Figure 3.10 PostScript Menu options showing factory settings
Option
Setting
Description
Copies
1*
- 99 Number of times each page is printed.
Most software applications override this setting. If
your application does not, the printer assumes the
default setting here.
Default Tray
Upper*
Middle
Lower
Manual
HCF
†
HCEF
†
†
Appears only when the
option is installed.
Paper tray used if none is specified in your software
application.
Tray Switching
Note: The default for Tray
Switching is
Up-Mid-Low
or
HCF-Up-Mid-Low
for
firmware releases < 4.06.
The default is
Off
(as
shown at right) for releases
4.06 and higher. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
Off
Upper-Middle
Upper-Lower
Middle-Lower
Up-Mid-Low
HCEF-Upper
†
HCEF-Middle
†
HCEF-Lower
†
HCEF-Up-Mid
†
HCEF-Up-Low
†
HCEF-Mid-Low
†
HCEF-Up-Mid-Low
†
HCF-Upper
†
HCF-Middle
†
HCF-Lower
†
HCF-Up-Mid
†
HCF-Up-Low
†
HCF-Mid-Low
†
HCF-Up-Mid-Low†
†
Appears only when the
option is installed.
Sequence of trays the printer uses when printing a
page of a PostScript print job.
If the tray requested for the page is included in this
sequence then the whole sequence is used instead of
the requested tray, the first tray used is the first one in
the sequence, going from left to right, that satisfies all
page requirements. If the requested tray is not
included in this sequence then the requested tray
alone is used. For example if this setting is
“Upper-Lower” and the lower tray is requested then
the upper tray will be used first provided that it
contains the requested size of paper.
When this sequence is being used and the current tray
runs out of paper then the next tray in the sequence
that has the same size paper will be used.
Settings that begin with HCEF only appear when a
High Capacity Envelope Feeder is installed.
Settings that begin with HCF only appear when a
High Capacity Feeder is installed.
The factory default is HCF-Up-Mid-Low when an HCF
is installed or Up-Mid-Low when an HCF is not
installed.
PostScript drivers other than the Xerox driver may
simply enable or disable
Tray Switching
; they can
not specify a setting.
WUG-CH03 Page 33 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM