Filter
Top Products
Print Quality Problems
7-48
❖
4520/4520mp User’s Guide
Unfused or partially
fused image
The printed image is not
fully fused to the paper
and easily rubs off.
1. Damp paper stock
2. Heavy or unusual paper stock
3. Light image density
4. Defective Fuser Module
1. Replace paper stock.
2. Refer to
Chapter 2
for printer
throughput capabilities.
3. Replace EP cartridge.
4. Contact your dealer or Xerox / Rank
Xerox.
Skewed prints
Printed image is not
parallel to the edge of
the paper.
1. Paper improperly loaded into
paper tray
2. Obstructed paper path
3. Contaminated paper path
4. Dirty/worn Paper Feed Rolls
1. Check trays for proper paper loading
(see
Chapter 2
).
2. Inspect paper path for obstructions
(torn pieces of paper, etc.).
3. Inspect/clean paper path to remove
residual toner and paper dust.
4. Contact your dealer or Xerox / Rank
Xerox.
Figure 7.6 Print Quality Problems
(continued)
Problem
Possible Causes
Corrective Actions
WUG-CH07 Page 48 Black,Red,Cyan Wednesday, January 25, 1995 3:45 PM