Filter
Top Products
PCL Menu
Chapter 3: Using the Control Panel
❖
3-21
Point Size
4.00 - 999.75 by .25
(
12.00*
)
Point size (a measurement for type height, 1 point
equals 0.351 mm or approximately 1/72 inch) for the
font represented by
Font Number
(page 3-20).
Appears only when the
Font Number
setting
specifies a scalable proportional spaced font, such as
Times New Roman.
Most software applications override this setting. If
your application does not, the printer assumes the
default setting here.
Default Source
Upper*
Manual
Manual Envelope
Lower
Large Capacity
†
Envelope Feeder
†
†
Appears only when the
HCF (for Large Capacity)
or HCEF (for Envelope
Feeder) option is installed.
Default paper source in PCL if none is specified by
your software application.
The printer uses
Default Source
when there is no
paper source specified in the print job. Some software
applications have a paper source selection called
“Auto Select” or “Auto Sheet Feed” which usually
results in the omission of a paper source selection in a
print job.
When the printer uses
Default Source
,
Source
Mapping
(page 3-22) is used to determine the actual
tray or slot from which the printer pulls paper. See
Chapter 2: Handling Paper
,
“Selecting a Paper
Source” (page 2-30)
for more information on the
interaction of
Default Source
and
Source Mapping
.
Figure 3.8 PCL Menu options showing factory settings
(continued)
Option
Setting
Description
WUG-CH03 Page 21 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM