Filter
Top Products
Product Recycling and Disposal
Xerox 6204 Wide Format Solution 15
Before Using the Machine
1
Product Recycling and Disposal
If you are managine the disposal of your Xerox product, please note that the product
contains lead, mercury, and other materials whose disposal may be regulate due to
environmental considerations in certain countries or states. The presence of lead and
mercury is fully consistent with global regulations applicable at the time that the
product was placed on the market.
A full declaration of the conformity, defining the relevant directives and referenced
standards, can be obtained from your Authorized Local Dealer.
WEEE Directive 2002/96/EC
Application of this symbol on your equipment is confirmation that you must dispose of
this equipment in compliance with agreed national procedures.
In accordance with European legislation, end of life electrical and electronic
equipment subjec to disposal must be managed with agreed procedures.
Prior to disposal, please contact your local dealer or Xerox Representative for end of
life take back information.
Power Connection
Two power specifications are listed below. The specifications that apply to your
machine depend on your machine configuration and the requirements in your country.
Connect the power plug only to a properly rated and grounded power outlet to avoid
the chance of electric shocks. If in doubt, contact your Xerox Sustomer Support
Center.
1. Rated voltage 120 V
Rated frequency 50/60 Hz
2. Rated voltage 220-240 V
Rated frequency 50/60 Hz
Ensure that the plug connection is free of dust. In a damp environment, a
contaminated connector can cause connection problems over time.
Do not attempt to rework, pull, bend, chafe, or damage the power cord in any way. Do
not place heavy objects on the cord because that can also damage the cord.
Stop operation immediately if your machine produces smoke, excessive heat, unusual
noises or smells, or if water, coffee, or other liquids are spilled on the machine.
Immediately turn off the machine off and unplug it. Then contact your Xerox Customer
Support Center.
Environment and Temperature
The machine is designed to operate normally within the following recommended limits:
Temperature range: 50 - 90 degrees Fahrenheit (10 - 32 degrees Celsius)
Humidity range: 15 - 85% (no condensation)
At 47.5% humidity, the temperature should be 90 degrees F or below; and
at 85% humidity, the temperature should be 82 degrees F or below.
Note • Sudden temperature fluctuations can affect copy quality. Heating a cold room too quickly
can cause condensation inside the machine, which can interfere with image transfer.