Filter
Top Products
4 Scan
86 Xerox 6204 Wide Format Solution
Scan
4
Edge Erase (Erasing Edges and Margin Shadows of the Original)
When scanning certain original documents, black shadows sometimes appear along
the edges of the paper. If this happens, you can scan with the shadows erased.
Note • When Reduce/Enlarge is set, the edge erase amount is also enlarged or reduced in
proportion to the scan ratio.
1 Select [Edge Erase].
2 Select the type of edge erase.
3 Set the width to be erased for each of the lead, trail, left, and right edges, using the
numeric keypad or [ ][ ].
Normal Erase
The edge erase amount is set to 2 mm for the lead, trail, left, and right.
Border Erase
Shadows at the lead, trail, left, and right of the
original are erased with the same edge erase
amount. You can set the edge erase width within
the range of 0 to 50 mm in 1 mm increments.
Edge Erase
Edges on the lead (top), trail (bottom), left, and
right are erased independently. You can set the
edge erase width within the range of 0 to 50 mm
in 1 mm increments.
4 Select [Save].
Scan Start Position (Shifting the Start Position for Scanning the Original)
You can skip the unneeded portion of the leading part of the original by shifting the start
position for scanning the original.
The length from the edge of the originals to the start position can be set from 0 to 999
mm in 1 mm increments.
1 Select [Scan Start Position].
2 Set the scan start position using the numeric
keypad or [ ], [ ].
Note • When Reduce/Enlarge is set, the scan start
position is also enlarged or reduced in
proportion to the scan ratio.
3 Select [Save].