Filter
Top Products
7-26
Setup Menus
VT220-7 and VT220-8 modes run emulations of the DEC VT220 terminal, the
difference is in their treatment of 8-bit control codes. When VT220-7 is selected, all
8-bit codes are converted to their 7-bit equivalents, whereas VT220-8 leaves 8-bit
codes unchanged. If you are using VT200 applications, select VT220-7.
W3220 mode provides compatibility with software designed to drive the Westward
3220 terminal.
Code 1 Selects
Factory default: ANSI
The setting of this option determines what action will be taken on receipt of an 'Enter
ANSI Mode' (Code 1) command from the host. It can be set to cause entry to the
DEC VT220 7 or 8-bit emulation instead of ANSI (VT100). This provides the same
functionality as the Tektronix DecTerminal command.
Terminal ID
Factory default: VT100
This option identifies the particular 'VT' terminal model emulated by TeemTalk in
response to a terminal identification request from the host when in any mode except
Tek.
Multinational
Factory default: Unselected
The setting of this option determines whether the national or multinational character
set is used when TeemTalk is in VT220 7 or 8-bit Alpha mode. (All other modes use
the national character set.)
When this option is unselected, the national character set which corresponds to the
keyboard language selected in the Terminal Settings dialog box will be used. Only
characters found in this character set may be generated.
When this option is selected, the multinational character set will be used. This
consists of the 7-bit ASCII character set and the 8-bit VT220 Additional character set
(as shown in the Character Sets appendix). This enables characters from all national
character sets to be generated.
Display Controls
Factory default: Unselected
The setting of this option determines whether received control codes are actioned or
displayed. When selected, a representation of most control codes will be displayed on
the screen.