Filter
Top Products
2-3
Getting Started
Host Communications
Creating A Communications Session
When TeemTalk is loaded for the first time, a dialog box will be displayed which
enables you to configure TeemTalk for a serial or network host connection.
Note: If you do not wish to make a host connection at this moment,
just click the Cancel button to close the dialog box. You can
display the New Connection dialog box again later by
clicking File in the menu bar and selecting New
Connection... in the menu.
The Type option specifies whether a serial or network connection is to be made.
Clicking the arrow button will display a drop-down list box containing all the
possible settings.
The Services option specifies the port or network host node which TeemTalk is to
communicate with. This is a text box with an associated drop-down list box. You can
either make a selection from the list box or enter a valid host name or internet address
in the text box.
Note: If you are unfamiliar with using dialog boxes and setup
menus, refer to the beginning of the Setup Menus chapter.
Making A Serial Host Connection
To connect to a serial host, select Serial in the Type list box (default), then select the
Com port required in the Services list box.
Click the Configure... button to display the Serial Settings dialog box (shown
overleaf) and make sure the settings match that of the host.
Click OK to return to the New Connection dialog box then click the Connect button.