Filter
Top Products
11-9
Initialization Commands
TeemTalk for Windows 95 & NT:
CTERM TCPIP
LAT TEEMTALKOSI
MULTILAN WINSOCK2
NETBIOS
Refer to the Network Connection chapter in the Networking Guide for a description
of these protocols.
Note that if you only specify the host name on the command line then TeemTalk will
assume you are using TCP/IP.
If you are using the NetBIOS protocol, refer to the NetBIOS Version section in the
Network Connection chapter of the Networking Guide for an additional initialization
file command that has to be included.
Load Winsock On Startup
Initialization File: LoadWinsockOnStartup=on
Command Line: -lw
Default Setting: Off
These commands will initialize the Winsock stack immediately when TeemTalk is
started, enabling dialup over PPP or SLIP to gain a connection to a service provider.
NetBIOS Version
Initialization File: UngBassExtendedNetBIOS=No/Yes
Command Line: Not applicable
Default Setting: No
This command is used to specify the version of NetBIOS being used when you select
NetBIOS for network communications. If you are using the Ungermann Bass Net-
One NetBIOS, set this command to Yes, otherwise set it to No.