Filter
Top Products
8-14
File Transfer
ZMODEM Parameters
Clicking the Zmodem... button in the Initiate File Transfer dialog box will cause the
ZMODEM Parameters dialog box to be displayed. This enables you to set
parameters specific to the ZMODEM protocol. The Send settings inform the remote
end how to treat the data that will be sent to it. The Receive settings will override any
Send settings specified at the remote end.
Once the settings have been selected, the initialization file can be modified to reflect
the changes under the heading [TeemTalkFTU,ZMODEM] by checking the Save
Settings box then clicking the OK button.
The zmodemStartup private profile file command or -zm command line option can
be used to make TeemTalk check incoming data for a remote ZMODEM startup
sequence then automatically start a file transfer using the settings specified in this
dialog box. Note that the transfer protocol selected in the Initiate File Transfer
dialog box will be ignored.
Data Conversion
Factory default: None
This specifies whether or not the file being transferred is converted to ASCII or
Binary format at the receiving end, or remains unchanged (None).