Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide — Basic Port Commands Chapter 1 Port Basic Configuration Commands
1-6
View
Any view
Parameter
interface-type: Port type.
interface-number: Port number.
Description
Use the display interface command to display port configuration.
When using this command:
z If you specify neither port type nor port number, the command displays information
about all ports.
z If you specify only port type, the command displays information about all ports of
the specified type.
z If you specify both port type and port number, the command displays information
about the specified port.
Example
# Display the configuration information of the Ethernet1/0/1 port.
<3Com> display interface Ethernet1/0/1
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc2c-3f11
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Allow jumbo frame to pass
Port monitor last value: 1
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input: 0 packets/sec 0 bytes/sec
Last 300 seconds output: 0 packets/sec 0 bytes/sec
Input(total): 1150 packets, 149854 bytes
542 broadcasts, 55 multicasts, - pauses