Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Multicast Chapter 5 PIM Configuration Commands
5-19
source-mask-length: Specifies mask length of the group address.
incoming-interface: Specifies incoming interface for the route entry in PIM routing
table.
interface-type interface-number: Specifies the VLAN interface.
Description
Use the reset pim routing-table command to clear all PIM route entries or the
specified PIM route entry.
You can type in source address first and group address after in the command, as long
as they are valid. Error information will be given if you type in invalid addresses.
If in this command, the group-address is 224.0.0.0/4 and source-address is the RP
address (where group address can have a mask, but the resulted IP address must be
224.0.0.0, and source address has no mask), then it means only the (*, *, RP) item will
be cleared.
If in this command, the group-address is any a group address, and source-address is 0
(where group address can have a mask, and source address has no mask), then only
the (*, G) item will be cleared.
This command shall clear not only multicast route entries from PIM routing table, but
also the corresponding route entries and forward entries in the multicast core routing
table and MFC.
Related command: reset multicast routing-table, reset multicast forwarding-table,
and display pim routing-table.
Example
# Clear the route entries with group address 225.5.4.3 from the PIM routing table.
<3Com> reset pim neighbor 25.5.4.3
5.1.21 source-policy
Syntax
source-policy acl-number
undo source-policy
View
PIM view
Parameter
acl-number: Basic or advanced ACL, in the range of 2000 to 3999.