Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 1 Static Route Configuration Commands
1-2
2.2.2.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
3.3.3.0/24 DIRECT 0 0 3.3.3.1 Vlan-interface3
3.3.3.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
4.4.4.0/24 DIRECT 0 0 4.4.4.1 Vlan-interface4
4.4.4.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
Table 1-1 Description on the fields of the display ip routing-table command
Field Description
Destination/Mask Destination address/mask length
Protocol Routing protocol
Pre Route preference
Cost Route cost
Nexthop Next hop address
Interface
Output interface, through which the data
packets destined for the destination
network segment are sent
1.1.2 display ip routing-table acl
Syntax
display ip routing-table acl { acl-number | acl-name } [ verbose ]
View
Any view
Parameter
acl-number: Number of the number-identified ACL, in the range of 2,000 to 2,999.
acl-name: Name of the basic name-identified ACL.
verbose: Displays the detailed information about active and inactive routes filtered by
the ACL rules if this keyword is provided; displays the brief information about the
active routes filtered by the ACL rules.
Description
Use the display ip routing-table acl command to display the routes filtered by the
basic ACL rules.
This command is mainly used to trace and display the routing policies, that is, to
display the routes filtered by the rules based on the input basic ACL numbers.