Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 1 Static Route Configuration Commands
1-14
Then, the statistics of the entire routing table will be output. Finally, the verbose
description of each route will be output.
The display ip routing-table verbose command can display all current routes,
including inactive routes and invalid routes.
Example
# Display the verbose routing table information.
<3Com> display ip routing-table verbose
Routing Tables:
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Destinations: 3 Routes: 3
Holddown: 0 Delete: 62 Hidden: 0
**Destination: 1.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 1.1.1.1 Interface: 1.1.1.1(Vlan-interface1)
State: <Int ActiveU Retain Unicast>
Age: 20:17:41 Cost: 0/0
**Destination: 1.1.1.1 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 20:17:42 Cost: 0/0
**Destination: 2.2.2.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 2.2.2.1 Interface: 2.2.2.1(Vlan-interface2)
State: <Int ActiveU Retain Unicast>
Age: 20:08:05 Cost: 0/0
Table 1-2 describes the meaning of route status and Table 1-5 shows the statistics
information about the routing table.
Table 1-5 Description on the fields of the display ip routing-table verbose
command
Field Description
Holddown Number of held-down routes
Delete
Number of deleted routes
Hidden
Number of hidden routes