Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – VLAN Commands Chapter 1 VLAN Configuration Commands
1-16
View
System view
Parameter
vlan-id: VLAN ID, ranging from 1 to 4094.
protocol-index: Beginning protocol index, ranging from 0 to 6. Its value must be smaller
than or equal to the value of the protocol-end argument.
protocol-end: End protocol index, ranging from 0 to 6. Note that its value must be larger
than or equal to the value of the protocol-index argument.
all: Specifies all protocol indices.
slot slot-number: Specify to associate a board with protocol-based VLAN. The
slot-number argument specifies board slot number.
mainboard: Main board
Description
Use the protocol-vlan vlan slot command to associate a board with protocol-based
VLAN.
Use the undo protocol-vlan vlan slot command to cancel the association.
Note that it is necessary to add those ports that require protocol in the board to the
protocol-based VLAN. Currently, only non-A-type boards, including service boards and
main control boards, support this command.
Table 1-3 shows the supported protocol-based VLAN creation commands on different
boards.
Table 1-3 Protocol-based VLAN creation commands on different boards
Command description A-type board Non-A-type board
Create protocol-based VLAN
on specific board in system
view.
Not supported Supported (for all IP protocols and
subnet IP protocols.
Create protocol-based VLAN
on specific port in Ethernet
port view.
Supported Supported (exclude all IP protocols
and subnet IP protocols.
Note:
A-type boards include 3C16860, 3C16861, 3C16858, 3C16859.
Related command: port hybrid protocol-vlan vlan and display protocol-vlan
interface.