Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 4 Integrated IS-IS Configuration Commands
4-7
You can use this command to view the mesh-group configuration of the current
routing interface.
Example
# Configure the IS-IS-enabled Vlan-interface 10 and Vlan-interface 20 of the router to
belong to mesh group 100.
<3Com> system-view
[3Com-Vlan-interface10] isis mesh-group 100
[3Com-Vlan-interface10] interface Vlan-interface 20
[3Com-Vlan-interface20] isis mesh-group 100
# Display the configuration information of the IS-IS mesh group.
<3Com> system-view
[3Com-Vlan-interface20] display isis mesh-group
Interface Mesh-group/Blocked
Vlan-interface 10 100
Vlan-interface 20 100
4.1.8 display isis peer
Syntax
display isis peer [ verbose ]
View
Any view
Parameter
verbose: Displays the area address advertised in a neighbor’s Hello packet when this
keyword is provided; displays only the brief information if this keyword is not specified.
Description
Use the display isis peer command to display the information of the IS-IS neighbor.
Besides all the information displayed by the display isis peer command, the display
isis peer verbose command will display the neighbor’s area address, holdtime of Up
state and the IP address of the directly-connected interface.
Example
# Display the detailed information about IS-IS neighbors.
<3Com> display isis peer verbose
System ID Interface Circuit ID State HoldTime Type Pri
0000.0000.6502 Vlan-interface1000 0000.0000.6502.02 Up 8s L1 64
Area Address: 01 IP Address: 7.7.7.7 Period: 01:51:13