3Com 7750 Series Switch User Manual


  Open as PDF
of 1177
 
3Com Switch 7750 Series
Command Reference Guide – QoS Chapter 1 QoS Commands
1-38
Note:
LPUs support applying the combination of IP ACL rules and link ACL rules. However,
the field defined by the IP ACL rules and link ACL rules cannot be of more than 32
characters. Otherwise, the combination cannot be applied successfully.
View
QoS view
Parameter
inbound: Performs traffic statistic on the packets received by the port.
outbound: Performs traffic statistic on the packets sent by the port.
acl-rule: Applied ACL rules which can be the combination of various ACL rules. For the
ways of combining ACLs and the description on related parameters, refer to
Table 1-4
and
Table 1-6.
system-index: Specifies an interior index value which is used when an ACL rule is
applied to the port. The index value ranges from 0 to 4294,967,295. This keyword is
only available when the ACL rule number is specified in the command. After the
specified ACL takes effect, there are three scenarios when you input the index value:
z If you do not input an index value or the index value you input is 0, the system will
automatically assign an index whose value is greater than 0;
z If the input index value is not 0 and does not conflict with the interior index used by
the system, the system will adopt the index value input by you;
z If the input index value is not 0 but conflicts with the interior index used by the
system, the system will reassign an index value.
When the specified ACL rule is not effective, the system will adopt the index value input
by you.
Description
Use the traffic-statistic command to activate the ACL for traffic identifying and count
the traffic. This command is applicable to only the permit rules in the ACL.
Use the undo traffic-statistic command to cancel the traffic statistics.
The statistics information of traffic-statistic command includes the times of ACL
matches on the hardware. You can use display qos-interface traffic-statistic
command to display the statistics information.
Related command: display qos-interface traffic-statistic.