Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Port Isolation Chapter 1 Port Isolation Configuration Commands
1-2
Parameter
group-id: ID of an isolation group, in the range of 1 to 64.
Description
Use the display isolate port command to display the configuration of the created
isolation group, including:
z ID of the isolation group
z Description string for the isolation group
z Ports that the isolation group contains
Example
# Display the configuration of isolation group 1.
<3Com> display isolate port group 1
Isolate group ID: 1
Description: home
Isolated port(s) in group 1:
GigabitEthernet1/0/3 GigabitEthernet1/0/1 GigabitEthernet1/0/2
1.1.3 port
Syntax
port interface-list
undo port interface-list
View
Isolation group view
Parameter
interface-list: List of destination ports, expressed in the form of interface-list =
interface-type interface-number [ to interface-type interface-number ] &<1-10>., where:
z The interface-type argument represents the bound port type;
z The interface-number argument represents the bound port number;
z The to keyword specifies a group of contiguous ports. The port number after the to
keyword must be no smaller than the port number before the to keyword.
z &<1-10> means that you can provide the port index for up to 10 times.
Description
Use the port command to add the specified ports to the isolation group.
Use the undo port command to remove the specified ports from the isolation group.
By default, an isolation group contains no Ethernet port.