Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – QoS Chapter 1 QoS Commands
1-34
only available when the ACL rule number is specified in the command. After the
specified ACL takes effect, there are three scenarios when you input the index value:
z If you do not input an index value or the index value you input is 0, the system will
automatically assign an index whose value is greater than 0;
z If the input index value is not 0 and does not conflict with the interior index used by
the system, the system will adopt the index value input by you;
z If the input index value is not 0 but conflicts with the interior index used by the
system, the system will reassign an index value.
When the specified ACL rule is not effective, the system will adopt the index value input
by you.
cpu: Redirects the traffic to the CPU.
interface { interface-type interface-number }: Redirects the packets to the specified
Ethernet port. The interface-type argument refers to the port type, and the
interface-number argument refers to the port number.
Description
Use the traffic-redirect command to enable the ACL to identify and redirect the traffic.
This command is applicable to the permit rules in an ACL only.
Use the undo traffic-redirect command to disable the traffic redirect function. .
Related command: display qos-global traffic-redirect.
Note:
z Only type-A LPUs support this command.
z Only the permit rule can be referenced in this command and applied to hardware.
Example
# Redirect the packets matching the permit rule in ACL 2000 to GigabitEthernet1/0/1.
<3Com> system-view
[3Com] interface GigabitEthernet1/0/1
[3Com-GigabitEthernet1/0/1] qos
[3Com-qosb-GigabitEthernet1/0/1] traffic-redirect inbound ip-group 2000
interface gigabitethernet1/0/1