Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 5 BGP Configuration Commands
5-49
Related command: reflector cluster-id, and peer reflect-client.
Example
# Disable the reflection between clients.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] bgp 100
[3Com-bgp] undo reflect between-clients
5.1.56 reflector cluster-id
Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
View
BGP view
Parameter
cluster-id: Cluster ID of the route reflector, an integer number ranging from 1 to
4294967295, or an IP address in dotted decimal notation.
Description
Use the reflector cluster-id command to configure the cluster ID of the route
reflector.
Use the undo reflector cluster-id command to delete the cluster ID of the route
reflector.
By default, each route reflector uses its Router ID as the cluster ID.
Generally, there is only one route reflector in a cluster. In this case, Router ID of the
route reflector is used to identify the cluster. Setting multiple route reflectors enhances
network stability. If multiple route reflectors are in a cluster, use this command to
configure the same cluster ID for all the route reflectors to prevent route loop.
Related command: reflect between-clients, and peer reflect-client.
Example
# A local router is one of the route reflectors in a cluster. Set the cluster ID of the route
reflector as 80.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] bgp 100
[3Com-bgp] reflector cluster-id 80