Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Configuration File Management
Chapter 1 Configuration File Management
Commands
1-10
Related command: startup saved-configuration.
Example
# Display the configuration filenames used for the current and the next start-ups.
<3Com> display startup
MainBoard:
Startup saved-configuration file: flash:/vrpcfg.cfg
Next startup saved-configuration file: flash:/vrpcfg.cfg
1.1.5 reset saved-configuration
Syntax
reset saved-configuration
View
User view
Parameter
None
Description
Use the reset saved-configuration command to erase configuration files from the
flash memory of the Ethernet Switch.
Perform this command with cautious. It is suggested to consult technical support
personnel first.
Generally, this command is used in the following situations:
z After upgrade of software, configuration files in flash memory may not match the
new version's software. Perform reset saved-configuration command to erase
the old configuration files.
z If a used Ethernet Switch is applied to the new circumstance and the original
configuration files cannot meet the new requirements, the Ethernet Switch
should be configured again. Erase the original configuration files for
reconfiguration.
If the configuration files do not exist in the flash memory when Ethernet Switch is
electrified and initialized, it will enter setup switch view automatically.
Related command: save, display current-configuration, display
saved-configuration.
Example
# Erase the configuration files from the flash memory of the Ethernet Switch.