Filter
Top Products
3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 6 IP Routing Policy Configuration Commands
6-3
Example
#Create a Route-policy named setcommunity and set its node sequence number as
16 and matching mode as permit. Enter route policy view and set matching conditions
and execute attribute change command
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com]route-policy 10 permit node 10
[3Com] route-policy setcommunity permit node 16
[3Com-route-policy] if-match as-path 8
[3Com-route-policy] apply community no-export
6.1.3 apply cost
Syntax
apply cost value
undo apply cost
View
Route policy view
Parameter
value: Route cost value of route information. The value ranges from 0 to 4294967295.
Description
Use the apply cost command to configure the route cost value of route information.
Use the undo apply cost command to cancel the apply statement.
By default, no apply statement is defined.
An apply statement of Route-policy sets the cost of the routes passing the filtering.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply origin, and apply tag.
Example
# Define an apply statement. When it is used for setting route information attribute, it
sets the route cost value of route information as 120.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] route-policy policy_10 permit node 12
%New sequence of this list
[3Com-route-policy] apply cost 120