Filter
Top Products
Managing the AMASS File System
6-00028-01 Rev A Command Reference 3-75
The idle eject drivestat -e secs drivenumber command will
override the global IDLETIME setting on a per drive basis.
The following figure illustrates how both the global IDLETIME
parameter and the per drive drivestat command option
affects your drives:
To disable the idle eject feature for all your drives, both the
global IDLETIME parameter and the per drive drivestat
command must be set to zero. The following table summarizes
the correlation between the global and per drive values:
Note
If the global IDLETIME parameter has been set to a non-zero value,
although you can physically reset the idle eject value to zero with
the
drivestat command, the feature will not be disabled.
Drive1
Drive2
Drive3
Global IDLETIME Parameter
Drive1
Per Drive drivestat -e
sec
drive#
Command
The IDLETIME parameter
configured during AMASS
installation affects all drives.
The drivestat command
configured any time during
AMASS operation affects
behavior on a specified drive.
Behavior Global Per Drive
Per Drive value takes affect N/A >0
Global value takes affect >0 0
Feature disabled 0 0