Filter
Top Products
Managing the AMASS File System
6-00028-01 Rev A Operational Tasks 2-9
Replace a Full Backup Volume
AMASS issues a warning message when the Backup Volume is
almost full.
If you receive a “95% full” message before a backup starts,
initialize a new Backup Volume and perform a full backup as
described in the following table.
However, if you receive a “95% full” message while a backup
is in progress, the backup procedure may fail in which case you
must rerun the procedure with a new Backup Volume.
Note
For detailed information on the commands used in these steps, see
the "Command Reference" chapter.
Step Command Description
1 Log in as amass or root.
2 After you have unloaded a full Backup Volume by entering
the following command, store the backup volume in a safe
place.
Step Command Description
3 To continue, see “Prepare Media to be the Backup
Volume” on Page 1-3.
# voloutlet
1
The volume number of a Backup
Volume must be number 1.