Filter
Top Products
Mac mini (Mid 2010) Take Apart — General Information 89
2010-08-03
General Information
Tools
The following tools are required to service the computer:
• ESD wriststrap and mat
• Torx T6, magnetized
• Torx T8, magnetized
• Torx T9, magnetized
• Hex 2mm (or 5/64-inch) wrench
• #0 Phillips screwdriver
• Logic board removal tool (922-9588)
Important: This is a required tool to service the Mac mini (Mid 2010)
• Tweezers (optional)
• Black stick (922-5065), or other non-conductive nylon or plastic tool
• Soft cloth (to protect removed parts from scratches)
• Isopropyl alcohol and cleaning cloth (if needed)
• Scissors or razor knife to cut tape to size (if needed)
• Screw tray
Note: The logic board removal tool is required to dislodge the logic board assembly. Dislodging
or removing the logic board assembly is required to access many parts (see the First Remove
Hierarchy heading).
Refer to Knowledge Base article “Hand Tools for Desktop and Portable Repairs--AP/CA/EU/JP/
LA/US” to purchase tools:
http://support.apple.com/kb/HT3452
Cosmetic Care
Cosmetic surfaces have a high exposure to potential damage or scratching, due to the method
of working on the Mac mini (Mid 2010). Be extremely careful not to damage the housing and
other cosmetic surfaces with inadvertent tool movements, or to damage the cosmetic Mylar on
the top hard drive when removing or installing. In general, avoid scratching interior or exterior
surfaces, and avoid leaving ngerprints.
Reassembly Steps
When there are no replacement steps listed, replace parts in the exact reverse order of the
Removal procedure.
Important: Do not overtighten screws. Install all screws by hand. Do not use power tools.