Filter
Top Products
Mac mini (Mid 2010) Take Apart — General Information 94
2010-08-03
Top hard drive ambient thermal sensor (ex cable) (076-1370):
(This sensor is also replaceable by replacing the ex cable, which comes with the sensor installed.)
1. Remove the adhesive cover and attach the sensor pad to the ex cable where shown below.
2. Verify the ex cable is installed on the hard drive.
3. Cut approximately a 1.5 cm length of the supplied black Kapton tape.
4. Orient the round end of the tape up, center the tape over the sensor and press to secure the
tape over the sensor and to the ex cable, then wrap the ends of the tape over the top and
bottom of the hard drive, as shown.