Filter
Top Products
Installing UnixWare Client Software
Issue 1 October 2003 113
5. At the command prompt, enter the pkgadd command.
The pkgadd command format is as follows:
pkgadd -d /mountpoint/client/tsapi/unixware/nwtslib.spl
where mountpoint is the name of an existing directory (such as /cdrom1 or
/CD-ROM_1) on which to mount the CD-ROM. (Note that the full pathname, beginning
with a ’/’, is required.)
6. The system now displays a list of the packages in the spool file. Press <Enter> to
select the nwtslib package.
7. Specify the transport type.
UnixWare clients can use either IPX/SPX or TCP/IP as their network transport. The
system displays a list of transports and the following message:
Please specify a transport type for the Telephony Services
library. (To access Windows NT, Windows 2000 or Windows XP
Telephony Servers, you must select "tcp.")
spxIPX/SPX Protocol
tcpTCP/IP Protocol
Select a transport type [?,??]
Type "s" for IPX/SPX or "t" for TCP/IP; then press <Enter>.
Note:
Note: This release of Telephony Services for Windows NT, Windows 2000,
Windows XP only supports TCP/IP as a network protocol; you must select
TCP/IP even though both options appear on the screen.
8. The pg command displays the Telephony Services "readme" file, tslib.readme.
This file contains information about changes that were made after the manuals were
completed.
9. The installation is complete. Unmount the CD-ROM.
The umount command format is as follows:
umount /dev/cdrom/device
where device specifies the CD-ROM drive that contains the Telephony Services
installation disk. You may now remove the CD-ROM.
Note:
Note: If TCP/IP is selected for the transport type, a template file called /usr/lib/
tslibrc is created during installation. For more information, see
Editing the
Template File -- tslibrc on page 118.