Filter
Top Products
Cajun P550/P880/P882 Switch User Guide
Boot Mode
B-3
Password Recovery
The following command is used to reset the switch to the factory
default passwords.
initLogins
Syntax Boot> initLogins set <0=no change, 1=factory
default>
Description Using a value of zero will retain the current passwords in NVRAM
upon resetting the switch. Using a value of one will restore the
factory default passwords in NVRAM upon resetting the switch.
Downloading New Operational Code
To download new operational code in BOOT mode into APP1 or
APP2.
* Note: The P550/P880 does not have an IP address assigned to
the console ethernet port when it comes up in BOOT
mode. Therefore, a user must assign an IP address (and
default gateway) to the ethernet console port prior to
attempting the TFTP download of a new operational
image.
1. Ensure the ethernet console port is connected to the network
for a TFTP transfer (refer to the Cajun P550/P880 Switch
Installation Guide, “Chapter 3, Configuration”).
2. Enter the following command to assign an IP address to the
ethernet console port:
Boot> ip address <ip address> <ip mask>
3. Enter the following command to assign a default gateway to
the ethernet console port (if necessary):
Boot> ip default_gateway <ip address>
4. Enter the following command to download new operational
code to APP1 or APP2:
Boot> download <app1|app2> <serverIP>
<filename>