Filter
Top Products
CHAPTER 10: Switching Configuration
129
10.12Review Switching Configuration for an
Async Channel
To review the switching parameters of async
channels, enter the View Configuration Menu.
At this prompt, enter a channel or range of
channels (for example, DENVER/a2-a6).
The Multiserver will display the following
information for each async channel in the range:
COMMAND FACILITY MAIN MENU [node id]
VIEW CONFIGURATION
1
VIEW CONFIGURATION [node id
ASYNC CHANNELS
1
ASYNC CHANNEL
SWITCHING PARAMETERS
4
[node id] CHANNEL SWITCHING PARAMETERS
CONN UNBL RESOURCE DESTINTN CAL RCV CHAR CHANNEL MTRX
CH PROT RATE CLASS NODE/CLASS INH INH SET PASSWORD SWTC
-------------------------------------------------------------------------
A03 DED ON xxxxxxxx/xxxxxx NO YES ASC xxxxxxxx ENA
A04 DTR OFF xxxxxxxx NO NO ASC ENA
A05 AA ON YES NO NASC xxxxxxxx DISA
A06 DTR ON NO NO ASC ENA
ENTER CARRIAGE RETURN TO CONTINUE
ENTER TO NODE-ID/CHANNEL#
(^X TO ABORT):
CH The channel number
CONN PROT The connect protocol
(DED, DTR, or AA)
UNBL RATE Unbalanced rates (OFF or ON)
RESOURCE Resource class name (up to 8
CLASS characters possible)
DESTINTN Destination name of node and class
NODE/CLASS (up to 8 characters for node/class)
CAL INH Call inhibit (NO or YES)
RCV INH Receive inhibit (NO or YES)
CHAR SET Character set (ASC=ASCII or
NASC=non-ASCII)
CHANNEL Assigned password (up to 8
PASSWORD characters)
MTRX SWTC Matrix switching (ENA=Enable or
DISA=Disable)