Filter
Top Products
Multiserver 5000
42
5.3 Inter-Module Stacking Connectors
The modules are powered via the stacking
connector located on the front right side looking
from the front of the Multiserver unit. In Figure 5-3,
the back of the unit is shown, and the connectors
are therefore on the left. A stacking connector has
two parts: a shroud and a block. The shroud is on
the bottom of the module being installed and fits
over the block on the module below. As you
position the module, align the shroud and the
block. Press the two together until the connector is
completely coupled. Make sure that the holes in the
front of the module are aligned with the pins on
the spacer.
STACKING
CONNECTOR
(BLOCKS)
SHROUD
BLOCK
FRONT
Figure 5-3. Inter-module stacking connectors.
BACK