Filter
Top Products
Multiserver 5000
228
LOCAL DIGITAL Diagnostic The RD signal is being internally looped to the
LOOP LINK # ci TD signal and transmitted onto the VF line.
LOCAL DTE LOOP Diagnostic The TD signal is being internally looped to the
LINK # ci RD signal.
LOCAL FOX Diagnostic The port is in a local fox loopback test.
ni LOCAL LINK RESTART ci Event Node ni on link ci has been restarted.
ni LOCAL SYSTEM RESET Alarm The local Multiserver unit has been reset.
LOCAL TEST, ECHO INPUT Diagnostic The port has been placed into a local echo loopback
test.
LOCAL TX/RX TEST Diagnostic The TX test pattern generator and RX error
PATTERN LINK # ci detector have both been activated.
LOCAL VF LOOP LINK Diagnostic The local receiver VF signal is being routed into the
modem, looped out through the local transmitter,
and amplified through a variable gain stage.
LOCAL 1004 HZ Diagnostic The local modem is transmitting a test tone
TONE LINK # ci of 1004 Hz over the telephone line.
LOCKED PARAMETER Event This parameter is locked out by the hardware
configuration.
LOGGING REPORT, Event Command Facility is not available because it is
TRY LATER being used to send reports.
MODULE NOT OPERATIONAL Info LAN module is installed but not operational.
<NO ANSWER> Dialog Indicates that no answer was received from the
async destination port. Causes include the
following:
• Remote port did not respond to connection
protocol.
• No response was received within the call
timeout period from the remote Multiserver,
although the ports are known by the local
Multiserver.
• Call inhibit is enabled (on).
• DTR = low = OOS.
ni NO ANSWER LINK ci Event The calling process has discontinued due to the
absence of an answer tone on a local dial line.
Screen Display Messages
Message Message Type Explanation