Filter
Top Products
Multiserver 5000
232
ni TRANSMITTER RING Event A call is coming in on the transmitter side.
DETECT LINK ci
ni TX CONNECTION MADE Event A successful call was placed over the dial-lines
LINK # ci from the modem’s TX dial line connection. This
message is displayed by the call-originating modem.
<UNASSIGNED> Dialog • Node, class, module location, or port is unknown
in the network.
• Password for the class may be incorrect.
• If matrix switching is disabled, this message will
display when matrix switching is attempted.
<UNAVAILABLE> Dialog Requested resource exists, but is not in service (not
operational). Call inhibit may be off or DTR is off.
VOICE CHANNEL Event Voice/fax port c on node n has been put in a
[n/c] [condition] busyout state. [Conditions] may be the
BUSY OUT following:
System Where the link has experienced a sync
loss, a force-disable command, or a
force-disconnect command.
Forced Where the network operator has put the
channel in a busyout condition via a
forced-busy command.
VOICE CHANNEL [n/c] Event Termination of a busyout condition has
BUSYOUT CLEARED occurred on voice/fax channel c.
VOICE CHANNEL [n/c] Event The current dBm level for voice/fax port
INPUT LEVEL: nn dBm c on node n is nn (-25 to +1) dBm.
- [display] - Note: [Display] is a dynamic display
which appears on the screen.
VOICE CHANNEL [n/c] Diagnostic Voice/fax port c on node n has started the
LOCAL LOOP TEST diagnostic local loop test.
VOICE CHANNEL Event The voice/fax port has been reset and
[n/c] RESET re-initialized to the current configuration.
VOICE CHANNEL [n/c] Diagnostic Voice/fax port c on node n has completed
SELF TEST FAIL the internal diagnostic tests unsuccessfully.
VOICE CHANNEL [n/c] Diagnostic Voice/fax port c on node n has completed
SELF TEST PASS the self-tests successfully.
Screen Display Messages
Message Message Type Explanation