Filter
Top Products
CHAPTER 5: Module Installation
43
5.4 Blank Back Panel
The unit is delivered with blank back panels to
eliminate an open area in the rear of the unit where
there are no modules installed (Figure 5-4). Do not
discard unused blank back panels; they may be
needed later.
5.5 Disassembly Procedures
The disassembly of your Multiserver unit will
require access to the sides and top of the unit to
remove the cover, and to the rear to remove the
back panels. This may be accomplished with the
unit in its normal operating position provided there
is sufficient clearance—about six inches above the
unit and the length of a screwdriver on either side.
If there is not a sufficient amount of access space,
you will need to remove all external cables to move
the unit to a work space.
BLANK PANEL
Figure 5-4. The back of a multiserver unit with a blank panel.
Figure 5-5. Unplug the Multiserver before disassembly.