Filter
Top Products
Multiserver 5000
50
5.6.6 PUT THE COVER BACK ON
1. Be sure that all spacer positions have been filled
before replacing the cover to ensure proper
module connections.
2. Be sure blank back panels have been installed
into the back of the unit to eliminate open
spaces.
3. Be careful not to handle the delicate metallic
finger stocks when installing the cover. They are
located at the front and rear of the cover and
are needed to make contact with the bottom
enclosure to ensure compliance with FCC Part
15 or FTZ radiated emission standards.
4. The front of the cover has an interrupted strip
of metallic finger stocks. The back has a solid
strip. (See Figure 3-15.)
Identify the front of the cover, align it with the
front of the base, and place the cover over the
base. Lightly press the cover forward.
5. Insert screws in holes and screw them in with a
screwdriver. The screws should be tightened
until they stop turning under normal pressure.
AT BO A6 A5 A4 A3 A2 A1
Figure 5-16. Putting the cover back on the Multiserver.
Front
Back
Figure 5-15. The front and back of the cover.