Filter
Top Products
Appendix D: Messages
235
ARE YOU SURE? Info A reset is requested. If the answer is yes, press the
EXEcute key to proceed with the reset. If the
answer is no, press ANY OTHER KEY except the
EXEcute key to terminate without a reset.
ARE YOU SURE? Info You have attempted to reconfigure a node
EXE FORCES A RESET number and ID. This invokes a reset and this
message. Press EXE to accept the new config-
uration and invoke the reset. Press any other key to
abort.
BATTERY LOW ni Event or Alarm The CMOS battery at node ni is low, and a power
loss could result in a cold start of the system.
CHANNEL NOT Info The selected port is inoperative or the module
AVAILABLE location is empty.
CHANNEL TYPE NOT Info The port configuration for the selected port
APPLICABLE does not apply for the function requested.
Example: You request a channel reset for a port
configured as a link.
ni CMOS ERROR Event or Alarm The Multiserver software has detected a problem
writing to the Multiserver configuration area.
Contact your service representative.
CONFIGURATION ERROR Info An attempt was made to change the modem
NO ACTION TAKEN configuration, and the change did not take effect.
DIAL CONNECT MADE Event or Alarm The Automatic Dial Backup (ADB) option has
LINK ci completed the backup dial connection for link ci.
INTEGRAL DEVICE BUSY Info The system is very busy and you have attempted
modem diagnostics or configuration. Usually a
second attempt will succeed.
INTEGRAL DEVICE MODE Info You have attempted to execute a device
INHIBITS SELECTION function or option and the device is in a mode of
operation that temporarily inhibits the execution.
LCD Messages
Message Message Type Explanation