Filter
Top Products
Loading paper in the sheet feeder
The following features apply to use of the sheet feeder:
■ The sheet feeder can hold a stack of paper for automatic feed.
■ The sheet feeder can be adjusted to the width of a variety of standard
sizes.
■ Thick paper (max. 0.25 mm) must be printed one sheet at a time with
manual feeding and fed from the manual feed slot on the back of the
printer. (☞ 81)
■ The media listed in the table below can be loaded in the sheet feeder. The
number of sheets in the stack varies with the type of media you are going
to load.
Media Type Print Side Up Limit Page
Banner Paper Either side 1 (
☞ 74)
Bubble Jet Paper LC-301 Either side 100 (
☞ 59)
Envelopes No-flap side 15 (
☞ 60)
Fabric Sheet FS-101 Cloth side 1 (
☞ 78)
High Gloss Photo Film HG-201 Glossy Side 1 (
☞ 73)
High Resolution Paper HR-101 Whiter side 80 (
☞ 64)
Plain Paper (64~90 gsm) Either side 100 (
☞ 59)
Transparency CF-102 Either side 50 (
☞ 71)
T-Shirt Transfer TR-201 Rough side 1 (
☞ 77)
Glossy Photo Paper GP-301 Glossy side 20 (
☞ 65)
Glossy Photo Cards FM-101 Glossy side 20 (
☞ 68)
The media listed in the table above are available in a variety of standard
sizes. (☞ 56)
The procedure below describes how to load Plain Paper or Bubble Jet
Paper in the sheet feeder. For details about loading and handling other
media, refer to the referenced page numbers in the table above.
1
Slide the paper guide to a position slightly wide of the position mark
for the paper you want to load.
2
Check the envelope guides on both sides of the sheet feeder and make
sure they are both down and locked.
3
Pick up a stack of about 100 sheets and fan the stack to remove static
cling. Tap the front edge of the stack against a flat surface to make sure
the edges and corners of the stack are square.
44 Canon BJC-8500 User’s Manual