Canon LBP5200 Printer User Manual


 
Installing the Network Board (AXIS 1611)
6-14
Optional Accessories
6
Installing the Network Board
Use the following procedure to install the network board in the expansion board slot
at the rear of the printer.
CAUTION
Make sure that the printer is turned off and that all interface cables and power
cord are disconnected from the printer before installing the network board.
Attempting to install the board with the power on may result in electrical shock.
Take care when you are handling the network board. Do not touch the corners or
sharp areas of the network board as may cause personal injury.
IMPORTANT
The network board contains components that are sensitive to static electricity. To avoid
damaging the board due to static electricity, observe the following handling precautions.
-Touch a metal object to dissipate static electricity before handling the network board.
- When handling the network board, do not touch anything that generates static
electricity such as the computer display.
- Do not touch any of the components, printed wiring, or connectors on the network
board.
-To avoid the effects of static electricity, do not remove the network board from the
protective bag until immediately before you install it. The protective bag is also needed
when you remove the network board. Store the protective bag and do not discard of it.
NOTE
You will need a Philips-head screwdriver to install the network board. Prepare a
screwdriver in advance that matches the size of the screws.