Filter
Top Products
10-20 Special Sending Procedures Chapter 10
3. Use the numeric keypad to enter the time that you want to poll
the other fax.
❏ Set the time using the 24-hour system. If the hour or
minute is a single digit, precede it with a zero. For
example:
07:30 = 7:30 a.m.
17:05 = 5:05 p.m.
❏ If you make an error entering the time, press CLEAR. Then
enter the correct time.
4. Press START/COPY.
5. Dial the fax number(s) you want to poll.
❏ You can poll up to 97 destinations. See page 10-1 for
details.
6. Press START/COPY.
The LCD displays:
Your MultiPASS 1000 begins receiving the document at the preset
time.
❏ The MultiPASS 1000 beeps once when the document is
received without errors.
❏ The MultiPASS 1000 automatically redials if the other fax does
not answer or if the line is busy. (You can specify the number
of times it redials; see Auto Redial on page 5-17.)
❏ If an error occurs during reception, the MultiPASS 1000 beeps
intermittently for a few seconds. If this happens, try polling
again.
❏ To stop polling while receiving, press STOP.
❏ If the ALARM light is flashing, clear the error and press STOP. If
necessary, refer to Chapter 14, Troubleshooting.
06/21/95 17:10
TIMER
POLLING
TX/RX NO. XXXX
TEL=