Filter
Top Products
Contents
xiv
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Monitoring and Maintaining uRPF 13-4
Configuration Examples of uRPF 13-6
Configuring Loose Mode uRPF 13-6
Configuring Loose Mode uRPF with the allow-self-ping Option 13-7
Configuring Loose Mode uRPF with the allow-default Option 13-8
CHAPTER
14 Configuring Automatic Protection Switching 14-1
Multirouter Automatic Protection Switching 14-1
Feature History for MR-APS 14-2
Restrictions for MR-APS 14-3
Configuration Tasks for MR-APS 14-3
Configuring MR-APS on Unchannelized Line Cards 14-3
Configuring MR-APS on Channelized Line Cards 14-4
Configuring MR-APS with Static Routes 14-5
Configuring MR-APS with Static Routes on Unchannelized Line Cards 14-5
Configuring MR-APS with Static Routes on Channelized Line Cards 14-7
Monitoring and Maintaining the MR-APS Configuration 14-9
Single-router Automatic Protection Switching 14-9
Feature History for SR-APS 14-11
Configuring SR-APS 14-11
Disabling SR-APS 14-11
Monitoring and Maintaining the SR-APS Configuration 14-12
Threshold Commands 14-13
Specifying SR-APS Signal Degrade BER Threshold 14-13
Specifying SR-APS Signal Fail BER Threshold 14-14
CHAPTER
15 Configuring IP Multicast 15-1
Feature History for IP Multicast 15-2
Restrictions for IP Multicast 15-2
Configuration Tasks for IP Multicast Routing 15-2
Enabling IP Multicast Routing 15-3
Enabling PIM on an Interface 15-3
Enabling Dense Mode 15-3
Enabling Sparse Mode 15-4
Enabling Sparse-Dense Mode 15-4
Configuring Native Multicast Load Splitting 15-4
Configuring the Control Plane Protocol Policy 15-4