Filter
Top Products
1-25
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 1 Broadband Aggregation and Leased-Line Overview
New Features, Enhancements, and Changes
• SSO—Multilink PPP (MLP) in the Stateful Switchover feature guide, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/products_white_paper09186a00801ce6
f9.shtml
Note In Cisco IOS Release 12.2(28)SB, the Cisco 10000 series supports Route Processor Redundancy
Plus (RPR+) and Stateful Switchover (SSO). However, for broadband aggregation features the
Cisco 10000 series supports RPR+ only.
• Template ACLs in Chapter 25, “Configuring Template ACLs”
• Two-Rate Policer (also known as Dual Rate Three Color Policer) in the Cisco 10000 Series Router
Quality of Service Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
• Cisco IOS Release 12.2(28)SB Upgrade in the Upgrading to Cisco IOS Release 12.2(28)SB on a
Cisco 10000 Series Router, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_upgrade_guides09186a008059a
dee.html
New Features in Cisco IOS Release 12.3(7)XI7
The following features are new on the Cisco 10000 series router in Cisco IOS Release 12.3(7)XI7:
• Dynamic Subscriber Bandwidth Selection in the Cisco 10000 Series Router Quality of Service
Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
• L2TP Domain Screening, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_guide09186a00805a0
782.html
• Per Session Queuing and Shaping for PTA in the Cisco 10000 Series Router Quality of Service
Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
• Support for IP over Q-in-Q (IPoQ-in-Q)—IP packets that are double-tagged for Q-in-Q VLAN tag
termination on the subinterface level. For more information, see the PPPoE—QinQ Support feature
guide, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00801f0
f4a.html
• VRF-Aware VPDN Tunnels, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a008050
9f81.html