Filter
Top Products
22-42
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Configuration Examples for Configuring MLP
Configuring MLPoE over IEEE 802.1Q VLANs
Example 22-10 shows how to configure the PPPoE over IEEE 802.1Q VLANs:
Example 22-10 Configuring MLPoE over IEEE 802.1Q VLANs
policy-map policy_mlpoe_out
class class-default
shape average 2048000
policy-map policy_mlpoe_in
class class-default
shape average 512000
!
!
bba-group pppoe PPPoE
virtual-template 3
sessions per-vc limit 65530
sessions per-mac limit 65530
sessions per-vlan limit 8000 inner 1
!
interface Loopback3
ip address 13.0.0.1 255.0.0.0
!
interface GigabitEthernet1/0/0
ip address 1.0.0.1 255.255.0.0
negotiation auto
!
interface GigabitEthernet1/0/0.1
encapsulation dot1Q 2
pppoe enable group PPPoE
no snmp trap link-status
!
interface Virtual-Template3
ip unnumbered Loopback3
peer default ip address pool MLPoEpool
ppp authentication pap
ppp multilink
ppp multilink links max 1
ppp multilink interleave
ppp multilink fragment delay 8
service-policy output policy_mlpoe_out
service-policy input policy_mlpoe_in
!
ip local pool MLPoEpool 13.1.0.2 13.1.255.255
!
!
end
Note As MLPoE supports only single-member bundles, the ppp multilink links maximum 1 command must
be configured to restrict the number of links that join the bundle.
Configuring MLPoE through RADIUS
Example 22-11 shows how to configure the PPPoE on multiple link bundles through Remote
Authentication Dial-In User Service (RADIUS):
Example 22-11 Configuring MLPoE through RADIUS
cisco@domain_1
Password="cisco"
Service-Type=Framed-User,