Filter
Top Products
2-12
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 2 Scalability and Performance
Configuring the Cisco 10000 Series Router for High Scalability
help Provides a description of the interactive help
system.
hold-queue Sets the hold queue depth.
lan-name Specifies a name for the LAN that is attached to
the interface.
lapb X.25 Level 2 parameters (Link Access Procedure,
Balanced).
load-interval Specifies the interval for load calculation for an
interface.
locaddr-priority Assigns a priority group.
logging Configures logging for an interface.
loopback Configures the internal loopback on an interface.
mac-address Manually sets the MAC address for an interface.
max-reserved-bandwidth Specifies the maximum reservable bandwidth on
an interface.
mpoa Multiprotocol over ATM (MPOA) interface
configuration commands.
multilink Configures multilink parameters.
multilink-group Puts the interface in a multilink bundle.
netbios Defines Network Basic Input/Output System
(NetBIOS) access list or enables name-caching.
ntp Configures the Network Time Protocol (NTP).
priority-group Assigns a priority group to an interface.
qos pre-classify Enables quality of service (QoS) preclassification.
random-detect Enables weighted random early detection
(WRED) on an interface.
roles Specifies roles (by entering roles mode).
sap-priority Assigns a priority group.
sdlc Configures Synchronous Data Link Control
(SDLC) to Logical Link Control type 2 (LLC2)
translation.
serial Serial interface commands.
Table 2-7 Interface-Specific Commands That Prevent PPP Scaling (continued)
Command Function