Filter
Top Products
xxx
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
About This Guide
Audience
Description
Added the new features listed in the “New Features in Cisco IOS Release 12.3(7)XI1” section on
page 1-26.
Audience
This guide is designed for system and network managers responsible for configuring broadband
aggregation, leased-line, and MPLS services and on the Cisco
10000 series router. The manager should
be experienced using Cisco IOS software and be familiar with the operation of the
Cisco
10000 series router.
Document Organization
This guide contains the following chapters:
Cisco IOS Release Part Number Publication Date
Release 12.3(7)XI1 OL-2226-07 August, 2004
Chapter Title Description
Chapter 1 Broadband Aggregation Overview Lists new features and enhancements in each release; describes
hardware requirements. Provides examples of broadband and
leased-line architecture models.
Chapter 2 Scalability and Performance Describes limitations and restrictions, and how to configure the
Cisco
10000 series router for high scalability.
Chapter 3 Configuring Remote Access to MPLS
VPN
Describes the Remote Access (RA) to MPLS VPN feature that
allows the service provider to offer a scalable end-to-end VPN
service to remote users.
Chapter 4 Configuring Multiprotocol Label
Switching
Describes MPLS-related features, such as BGP Multipath load
sharing, Session Limit per VRF, and Half-duplex VRF.
Chapter 5 Configuring Layer 2 Tunnel Protocol
Access Concentrator and Network Server
Describes how to configure the Cisco 10000 series router as a
Layer
2 Tunnel Protocol Access Concentrator (LAC) or as an
L2TP Network Server (LNS). The managed LNS feature of the
Cisco
10000 series router enables the router to assign a
subscriber session to a VRF instance and route the session
within the VRF to the destination network.
Chapter 6 Configuring PPPoE over Ethernet and
IEEE 802.1Q VLANs
Describes the PPPoE over Ethernet feature that enables direct
connection to an Ethernet interface. Also describes the
IEEE
802.1Q VLANs feature that enables the
Cisco
10000 series router to support PPPoE over IEEE 802.1Q
encapsulated VLANs using Gigabit Ethernet.
Chapter 7 Configuring IP Unnumbered over VLAN Describes the IP Unnumbered over VLAN feature that helps
service providers to conserve IP address space for service
provider configurations that include Ethernet VLAN
subinterfaces.