Cisco Systems 10000 Network Router User Manual


 
Index
IN-10
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
managed LNS 5-1
configuration example 5-45
to VRF 1-5
MLPPP with LFI 1-23
MPLS carrier supporting carrier 1-23
MPLS egress netflow accounting 1-23
MPLS embedded management-LSP ping/traceroute
and AToM VCCV
1-23
MPLS-LDP MD5 global configuration 1-24
MPLS QoS 1-27
MPLS traffic engineering, diffserv aware 1-27
MPLS VPN-explicit null label support with BGP IPv4
label session
1-24
MQC policy map support on configured VC
range
1-26
MR-APS 1-27, 14-1
multicast-VPN 1-24
Multihop 9-1
ODAP 10-4
on-demand address pool manager 10-4
Overlapping IP Address Pools 10-16
percentage-based policing 1-27
per DSCP WRED 1-27
per precedence WRED statistics 1-28
per session queuing and shaping for PTA 1-25
per user tunnel selection 5-5
per VRF AAA 3-30, 5-23
policy map scaling 2-6
PPPoE over Ethernet 6-1
PPPoE over IEEE 802.1Q VLANs 6-7
PPPoE over Q-in-Q 1-28
pseudowire emulation edge-to-edge MIBs for Ethernet
and Frame Relay services
1-24
QoS broadband aggregation enhancements 1-26
queue scaling 2-7
RADIUS attribute 31
calling station ID 1-26, 16-13
RADIUS attribute screening 5-24, 16-1
RADIUS packet of disconnect 1-28, 16-17
RADIUS server load balancing 1-24
RA to MPLS VPN 3-31
Scaling limits for L2TP tunnels 1-24
session limit per VRF 4-15, 4-17, 4-19
session load balancing 5-6
session load failover 5-6
sessions per tunnel limiting 5-5, 5-37
shaped UBR PVCs 1-26
static tunnel selection 5-5
template ACL 25-1
template ACLs 1-25
time-based ACLs 1-28, 12-4
tunnel accounting 5-25
tunnel service authorization 5-4
tunnel sharing 5-4
two-rate policer 1-25
VBR-nrt oversubscription 1-28, 8-14
VC weighting 1-28
VLAN range 6-15
VRF-aware VPDN tunnels 1-25
WRED with queue limit 1-28
Federal Communications Commission
See FCC
FIB scaling 2-6
File Transfer Protocol
See FTP
flush, on input interface 2-19
Framed-Protocol RADIUS attribute 16-2, 16-3
Framed-Route VRF Aware feature 5-27
Frame Relay aggregation
leased-line architecture 1-10
Frame Relay over MPLS 20-28
DLCI-to-DLCI connections 20-28
PE devices supported 20-30
port-to-port connections 20-29
Frame Relay-to-Frame-Relay local switching
feature
20-31
QoS restrictions 20-34
same-port switching 20-33
FTP 1-4