Filter
Top Products
22-43
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Verifying and Monitoring MLP Connections
Framed-Protocol=PPP,
Framed-IP-Address=255.255.255.254,
Cisco-avpair = "lcp:interface-config=ppp multilink",
Cisco-avpair = "lcp:interface-config=ppp multilink interleave",
Cisco-Policy-Down = "policy_mlpoe_in"
Note A PPPoE session shaper is required on the virtual template, or must be applied through RADIUS to avoid
flooding a downstream device such as an ADSL2+.
Verifying and Monitoring MLP Connections
To verify and monitor MLP connections, enter the following commands in privileged EXEC mode:
Command Purpose
Router# debug ppp multilink events
Displays information about events affecting multilink groups
established for Bandwidth Allocation Control Protocol (BACP).
Router# show atm pvc
Displays all ATM permanent virtual circuits (PVCs) and traffic
information.
Router# show interfaces type number
Displays statistics for the interface you specify. If you do not
specify a specific interface, statistics display for all interfaces
configured on the router.
Router# show interfaces virtual-access number
[configuration]
Displays status, traffic data, and configuration information about
the virtual access interface you specify.
Note This command currently displays statistics for system
traffic only. Statistics for bundle traffic do not display.
For information about bundle traffic, see the show
interfaces or show ppp multilink command.
number is the number of the virtual access interface.
(Optional) configuration restricts output to configuration
information.
Router# show interfaces multilink group-number
[stat]
Displays configuration information about the MLP bundle you
specify.
group-number is a nonzero number that identifies the multilink
bundle.
(Optional) stat displays traffic statistics for the MLP bundle such
as the number of packets in and out.
Router# show ppp multilink [bundle-interface]
Displays bundle information for all of the MLP bundles and their
PPP links configured on the router.
(Optional) bundle-interface specifies the multilink interface (for
example, Multilink5).
If you specify bundle-interface, the command displays
information for only that specific bundle.
Router# show running-config
Displays information about the current router configuration,
including information about each interface configuration.