Filter
Top Products
9-12
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 9 Configuring Multihop
Monitoring and Maintaining Multihop Configurations
Example 9-4 show interface virtual access Command
Router# show interface virtual-access 3
Virtual-Access3 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 128 Kbit, DLY 100000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
LCP Open, multilink Open
Open: IPCP
Last input 00:02:30, output never, output hang never
Last clearing of "show interface" counters 1d19h
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 21/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
55930 packets input, 3347967 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
105261 packets output, 9607052 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions