Filter
Top Products
22-28
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Configuring MLP Bundles and Member Links
To configure MLP bundles and member links, perform the following configuration tasks:
• Creating an MLP Bundle Interface, page 22-28
• Enabling MLP on a Virtual Template, page 22-30
• Adding a Serial Member Link to an MLP Bundle, page 22-31
• Adding an ATM Member Link to an MLP Bundle, page 22-32
The following configuration tasks are optional:
• Moving a Member Link to a Different MLP Bundle, page 22-35
• Removing a Member Link from an MLP Bundle, page 22-36
• Changing the Default Endpoint Discriminator, page 22-37
Creating an MLP Bundle Interface
To create an MLP bundle interface, enter the following commands beginning in global configuration
mode:
Table 22-8 Requirements for Configuring MLP
Type MLP Bundle Member Links Virtual Template Service Policy
MLP over Serial Required Required Not required Not required
Single-VC MLP over ATM Required Required Required Required
1
1. A service policy is required only when configuring MLP-based link fragmentation and interleaving (LFI) for Single-VC or
Multi-VC MLP over ATM. For MLP-based LFI, a service policy with a priority queue defined must be attached to the
multilink interface. The VC does not require a service policy.
Multi-VC MLP over ATM Required Required Required Required
1