Filter
Top Products
Index
IN-18
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
P
Packet buffer usage 22-21
Packet processing rate 22-22
PAP 5-29, 5-34, 1-7
parallel express forwarding
See PXF
passive mode 2-19
Password Authentication Protocol 5-34, 1-7
Path validation
uRPF 13-1
PBHK service restrictions 2-3
PBHK translations 2-5
PBLT 22-20
PCR 1-7
peak cell rate 1-7
peer default ip address command 10-10
percentage-based policing 1-27
per DSCP WRED 1-27
performance
routing engine 1-1
Performance and Scalability of MLP on LNS 22-21
permanent
virtual circuit 1-7
virtual circuit or connection 1-8
virtual path 1-8
PE router 1-7
verifying
PE to CE routing sessions 3-46
PE to PE routing sessions 3-45
per precedence WRED statistics 1-28
per session queuing and shaping for PTA 1-25
per user tunnel selection 5-5
per VRF AAA
configuring 3-30
description 5-23
verifying 5-35
PIM
configuring on an interface 15-3
enabling
dense mode 15-3
sparse mode 15-4
sparse or dense mode 15-4
IP multicast feature 15-1, 15-3
ping command 3-41, 3-47, 10-16
Point-to-Point Protocol
See PPP
point-to-point subinterface 1-8
policy map
scaling 2-6
policy map command
counting as policy map 2-6
pool group
configuring 10-17
displaying statistics 10-18
IP overlapping address pools example 10-18
local pool group 10-17
verifying 10-18
VPN and VRF IP overlapping address pool
example
10-19
pool-member command 9-7
port mode 20-21
port-to-port connection 20-28
PPP
authentication timeout 2-10
definition 1-8
scaling and interface-specific commands 2-11
sessions
address allocation 10-5
ppp authentication command 5-29, 5-34
ppp authorization command 5-34
ppp multilink command 22-10
ppp multilink fragment disable command 22-12
ppp multilink interleave command 22-11, 22-12, 22-29
PPPoA 1-8
PPPoE
changing MAC address selection 3-20
circuit-tag processing 1-26