3-50 Diagnostic Tools
DAAD Diagnostic Messages
continued
Message Description Recommended Action
Accelerator
status: Cache
was
automatically
configured
during last
controller
reset. This can
occur when
cacheboard is
replaced with
one of a
different size.
Cache board was probably
replaced with one of a different
size.
Nothing needs to be done. Normal
operations
should continue.
Accelerator
status: Valid
data found at
reset
Valid data was found in posted
write memory at reinitialization.
Data will be flushed to disk.
Not an error or data loss condition. No
action needs to be taken.
Accelerator
status:
Warranty alert
Catastrophic problem with array
accelerator board. Refer to other
messages on Diagnostics screen
for exact meaning of this message.
Replace the array accelerator board.
Adapter/NVRA
M ID mismatch
EISA nonvolatile RAM has an ID
for a different controller from the
one physically present in the slot.
Run the System Configuration Utility.
Battery pack X
below
reference
voltage
Battery pack on the array
accelerator is below the required
voltage levels.
Allow enough time for batteries to recharge
(36 hours). If batteries have not recharged
after 36 hours, replace the array accelerator
board.
Battery X not
fully charged
Battery is not fully charged. If 75% of the batteries present are fully
charged, the array accelerator is fully
operational. If more than 75% of the
batteries are
not
fully charged, allow 36
hours to recharge them.
Board not
attached
Array controller configured for use
with array accelerator board, but
one is not attached.
Attach array accelerator board to array
controller.
NVRAM
configuration
present,
controller not
detected
EISA nonvolatile RAM has a
configuration for an array controller
but there is no board in this slot.
Either a board has been removed
from the system or a board has
been placed in the wrong slot.
Place the array controller in the proper slot
or run the System Configuration Utility to
reconfigure nonvolatile RAM to reflect the
removal or new position.