3-77
Compaq ProLiant 1850R Servers Maintenance and Service Guide
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
continued
Pager Data Setting Description
Dial-out status Enabled Allows ASR-2 to dial out to a remote workstation. If you selected
this option,
Dial-In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled and
set the Dial-Out String to the correct phone number. You must
also set the Reset Boot option to Boot Compaq Utilities. When
the system restarts because of an ASR reset, the administrator
is paged via Pager Status and Pager Dial String, the system
restarts to the Compaq Utilities, and dials out to the phone
number provided in the Dial-Out string. The dial-out number will
be tried five times. If it fails to connect after five attempts, the
modem is put in auto-answer mode.
Dial-out string 555-1234 Enter the dial string followed by the remote computer telephone
number.
Network status Enabled To allow network access to Compaq Utilities, set Network Status
to Enabled and make sure the Reset Boot option is set to Boot
Compaq Utilities.
Network
protocol
To use IPX network access, set Network Protocol to IPX. When
the system restarts to the Compaq Utilities because of an ASR
reset, it loads IPX network support. This enables remote access
via NVT.
To use IP network access, set Network protocol to IP. Also
make sure to set Network IP address, Network IP net mask, and
Network IP router address. When the system restarts to the
Compaq Utilities because of an ASR reset, it loads IP network
support. This enables remote access via Telnet.
NOTE:
The Network Status must be set to Enabled for network
access.
Network
controller
Compaq For all Compaq Standard Network Controllers.
Network host
name
CPQHOU Enter the network name of the server. Use underscores instead
of spaces within the name, for example, Compaq_Server. If you
are using IPX network access to the Compaq Utilities, this
server name is used to advertise NVT host services. This server
name displays in the Compaq Insight Manager server list when it
determines it can communicate via NVT. Set this name to be the
same as the server name you assign when the host OS is
running.